Pro 2030
It's a wonderful scanner there, Roy. I bought it (used the 10% 
Off New Items coupon in the new catalog) and modified it. 
The mod takes about 2 seconds. :-) I'm in a high RF area, so 
intermod was pretty bad. I swapped the tiny Pro2030 with a 
friend's BC890XLT that has a PL board. (I'd sold him my 
BC890XLT about a month ago to make room for the upcoming 
BC8500XLT, but decided against the 8500 in the end. <g>)
 
Anyways, take out the screws so you can open up the 2030. 
Looking down into the top of the scanner right behind the 
front panel you'll notice a little metal loop that's labeled 
L201. CLIP that jumper and move the two pieces a little away 
from each other. The loop's so small and rigid that if you 
ever need service, you could bend the to parts together and 
nobody would know you snipped them.